View Single Post
Old 12-19-2020, 05:19 AM   #276
clsmooth
Scooby Specialist
 
Member#: 86394
Join Date: May 2005
Chapter/Region: VIC
Location: West Vancouver
Vehicle:
2000 RS Coupe
2005 Forester X SE

Default

Had some time tonight, I power-brushed the surface crud off the outward facing side of the hub and coated it.



Another thing I did as part of this phase was I might as well do a nice little upgrade to the rear brakes. Ordered some rotors intended for a 3rd gen Legacy. They're an inch larger and the parts are priced no different then RS ones.


The caliper on this corner was also starting to seize. Instead of getting another RS caliper and mix-n-match the right bracket for it, I order a whole 3rd gen Legacy caliper as well.



This was the reason for removing the rear dust shields earlier. The rotor slid right on over the handbrake shoes perfectly, and the caliper lined up and bolted directly to the hub. The rear brakes are big enough now that I can't pear over the top to line up the caliper bolts anymore Had to mount the caliper with me under the car from behind.

Subtle, but fills up a bit more space now.

* Registered users of the site do not see these ads.
clsmooth is offline   Reply With Quote