Thread
:
Walnut Blasting Subaru DIT engines
View Single Post
02-24-2017, 10:54 PM
#
5
Subie53013
Scooby Newbie
Member#:
457271
Join Date:
Oct 2016
Chapter/Region:
NESIC
Location:
Central Mass
Vehicle:
2016 WRX
WR Pearl Blue
This is what the intake ports and valves look like after 10,500 miles!!!!
Step 9
You can finally now clean the intake valves!!!.
Make sure to close the valves for each cylinder you work on. Use a socket wrench on the crank bolt.
I use a vacuum adapter from Bavarian autosport, No one makes one for the WRX so I guessed at a size which was a little too small but I used a piece of rubber to block any open space in the port. The wand from the blaster can fit within this little hole through the vacuum adapter so as you blast, the shop vac will suck up all the pieces while you work to make it less messy. A little mess happens but not as much as if you didn't have this adapter. This stuff shoots fast and goes everywhere if its open!
*
Registered users
of the site do not see these ads.
Last edited by Subie53013; 12-01-2017 at
09:11 PM
.
Subie53013
View Public Profile
Find More Posts by Subie53013