View Single Post
Old 02-28-2005, 05:47 PM   #9
dwx
Scooby Guru
 
Member#: 8343
Join Date: Jul 2001
Chapter/Region: MWSOC
Location: Atlanta, GA
Vehicle:
2005 2012 Jeep
2013 DGM BRZ

Default

Here are a few pictures. Honestly the APS beam is well made but it isn't going to do a whole lot in a crash. Once you figure out how you are going to mount the IC itself you may not have to cut as much out of the USDM beam as you think. The bumper cover holes aren't even close to the same place on the APS as the GC8 one.

GC8 mounting point for beam (two identical slots on each side):



JDM vs. APS bumper beam:



JDM vs. APS vs. USDM:



Other side:



Mockup of APS beam on GC8 front end:

* Registered users of the site do not see these ads.
dwx is offline   Reply With Quote