View Single Post
Old 06-12-2005, 05:26 AM   #5
Hotrodguru
Scooby Guru
 
Member#: 37210
Join Date: May 2003
Chapter/Region: TXIC
Location: Texas | New York
Vehicle:
2016 Subaru WRX
Black

Default

Assembly of hub back on car.

This is simple and you’re home free now. Make sure to take the opportunity at this time to clean out all the old grease from the CV Joint and replacing it with some nice new stuff. I like the Lucas Red “N” Tacky #2 which is good up to 540F. Once you freshly grease it, all you have to do is assemble it in the reverse order of which you disassembled. Make sure to torque all the bolts back to factory specs. Last thing to do is to tighten the axle nut and bending it down to lock on the axle. I had someone hold the brakes when I tightened it up and that was it.










Breakdown on front axle assembly



* Registered users of the site do not see these ads.

Last edited by Hotrodguru; 12-26-2012 at 04:28 PM.
Hotrodguru is offline   Reply With Quote