View Single Post
Old 06-12-2005, 12:52 PM   #6
Scooby Guru
Member#: 7958
Join Date: Jul 2001
Location: Plains of Eastern Montana
09 GH B+


Thank you kind Sir! We (me ) have been wanting to see a nicely outlined tutorial for a long time.

Couple of questions if I may- the sockets used to press out/in are common sizes- you don't recall how big the biggest one was by chance?

What's the purpose of the bearing seperator? Does the used bearing need to be seperated?

good tip on the CV grease- are the bands difficult to reinstall - how is it done?

Did you repack the oem bearings w/ any "special grease? Would this be difficult to do if one wanted to (I've seen a couple of high temp greases mentioned in previous wheel bearing threads)?

Thanks again!

* Registered users of the site do not see these ads.
BIGSKYWRX is offline   Reply With Quote