View Single Post
Old 06-13-2005, 09:45 AM   #17
dwx
Scooby Guru
 
Member#: 8343
Join Date: Jul 2001
Chapter/Region: MWSOC
Location: Atlanta, GA
Vehicle:
2005 2012 Jeep
2013 DGM BRZ

Default

I've done the bearings on all 4 corners, just as preventative maintenance. I would recommend replacing the factory grease.

I would also recommend not re-using the axle nuts, buy new ones. Don't torque the axle nut down with the car on the ground, and make sure you have a torque wrench that goes pretty high.

These days Subaru changes them with the upright on the car, using a couple specialty tools and just removing the axle/brake assembly .
* Registered users of the site do not see these ads.
dwx is offline   Reply With Quote