10-13-2002, 11:27 PM
|
#7
|
Moderator
Member#: 922
Join Date: Feb 2000
Chapter/Region:
MWSOC
Location: Schaumburg, IL
Vehicle:16 WRX (white) 04 FXT (red)
|
MoTeC M4
MoTeC M4
www.motec.com
- Is there a Subaru user base available for this ECU? If so, where?
No.
- An estimate of the ECU's pricing?
$1600-2000
- Is the ECU programmable by laptop, handheld controller, or both?
Laptop only.
- Does the ECU function in a "stand-alone" or "piggyback" fashion?
Stand-alone.
- Is the ECU delivered as a "kit", or a "plug and play" package? For what models?
No, kits/packages are not available for any model.
- What datalogging capabilities does the ECU have?
Onboard logging only.
- Does the ECU have the ability to control boost pressure?
Yes. Main Table (3D) 20 RPM sites x 10 Throttle sites or 10 Gear sites.
- Does the ECU allow for maps to be switched on the fly, and will it need to be "reset" before the map will take effect?
Unknown.
- Does the ECU have any sort of knock correction feedback?
Changes can be made to the map itself on the fly. Does not need to be reset.
- What type of correction factors (coolant temp, air temp, etc) does the ECU use?
Intake Air temp., Coolant temp.
- What oxygen sensors does the ECU unit utilize?
Narrow-band or wide-band (optional).
- Will the ECU drive low or high impedance injectors? Both impedance types?
Both.
- Will the ECU drive an additional 4 injectors (8 injector staged setup)?
Yes.
- What load references can the ECU use for tuning purposes?
MAP, MAF, or TPS.
- What resolution does the ECU offer in tuning (how many load points, RPM points, and what increments of adjustment)?
Fuel:
Main Table (3D) 40 RPM sites x 21 Load sites (840 points)
End of Injection (3D) 20 RPM sites x 11 Load sites
Individual Cylinder Tables (3D) 20 RPM sites x 11 Load sites
Hi/Lo Injector Balance (3D) 20 RPM sites x 11 Load sites
Hi/Lo End of Injection (3D) 20 RPM sites x 11 Load sites
Ignition:
Individual Cylinder Tables (3D) 20 RPM sites x 11 Load sites
Rotary Split 20 RPM x 11 Load sites
Dwell Time 20 RPM x 11 Battery sites
- Does the ECU have the ability to drive external hardware? If so, how many, and what type?
Yes, 2 additional configurable outputs.
- Will the ECU run off of the stock crank position sensor? Or will one need to be fabricated?
Yes, will run off the stock setup.
Last edited by 8Complex; 11-16-2002 at 02:15 PM.
|
|
|