View Single Post
Old 10-02-2013, 12:51 PM   #2
Mr Wrex
Scooby Specialist
 
Member#: 332887
Join Date: Sep 2012
Chapter/Region: Tri-State
Location: Orange County, NY
Vehicle:
2012 WRX stage 2+
DGM (sedan)

Default

If you're not going to use a turbo with a 3" opening, don't use the larger inlet. Think about it like this... vaccuum attachments cover different amounts of surface area. The larger the surface area where the air initially enters the "system", the slower the air will move. As the area for the air to move through becomes smaller, the air will start to move into the "system" faster. If, for example, we use a vaccuum attachment that has the same inner diameter as the rest of the piping leading to the "system", the air's speed will stay the same speed at all times. Overall, it doesn't matter which size attachment you use... the air will still flow through the "system" at the same rate since you aren't changing the diameter of the piping all the way to the engine.

Another example... go suck air through a straw. Then after, attack a cone with a larger opening to the end of the straw and try sucking air in again. Notice a difference? (you shouldn't)

In summary, you will only flow as fast as your smallest part will allow you to. I don't even have to discuss the possible downfalls of the adapter/reducer to prove that this is no bueno.
* Registered users of the site do not see these ads.
Mr Wrex is offline   Reply With Quote