View Single Post
Old 08-11-2019, 10:59 PM   #7
OH06Impreza
Scooby Newbie
 
Member#: 501799
Join Date: May 2019
Default

Well, we're back again...

We've replaced the canister and all pertinent solenoids to this 2006 Impreza NA, and we've replaced the filler neck and shutoff valve and we STILL cannot fill the tank properly. Not sure about the CEL yet as we need a drive cycle but I'm expecting it to come back on due to not being able to fill it up the correct way.

The filler neck came with new hard lines so those were replaced as well.

Is there any way to get at the other end of the smaller neck lines to disconnect them and blow air through them JUST to make sure there isn't a blockage somewhere?

Otherwise we're at a loss.

ANY help or insight is GREATLY appreciated.

Thank You!!
* Registered users of the site do not see these ads.
OH06Impreza is offline   Reply With Quote