View Single Post
Old 01-20-2009, 04:52 PM   #14
fastenova
Scooby Specialist
 
Member#: 38829
Join Date: Jun 2003
Chapter/Region: NWIC
Location: Tigard, OR
Vehicle:
Not your usual 1997
Legacy GT

Default

Quote:
Originally Posted by GrimmSpeed View Post
Sounds very similar to our NA RS build! the only problem we really ran into was adjusting the valve lash.. maybe check that out?

Mike
Mike,

Thanks for the reply. I just had a valve job done (valve seat grind, new stem seals, new retainers) and they adjusted the valve lash to factory spec. which is what John at Delta recommended. I was told by one member here to open them up a little bit, but I'm a little leery to do so since it's such a pain to adjust them all... especially since I've already got the motor installed!

What did you adust the lash to on your RS setup?

Aaron
* Registered users of the site do not see these ads.
fastenova is offline   Reply With Quote