View Single Post
Old 01-21-2009, 12:04 PM   #21
doubledribble
Scooby Specialist
 
Member#: 42912
Join Date: Sep 2003
Chapter/Region: MAIC
Location: Newark, DE
Vehicle:
2003 Outback Sport
bird **** & door dings

Default

you should NOT adjust the valve to factory specs...10/15 is factory. Jon & Ken at Delta have both recommended 8/10 intake/exhaust for the mild grinds.


Quote:
Originally Posted by fastenova View Post
Mike,

Thanks for the reply. I just had a valve job done (valve seat grind, new stem seals, new retainers) and they adjusted the valve lash to factory spec. which is what John at Delta recommended. I was told by one member here to open them up a little bit, but I'm a little leery to do so since it's such a pain to adjust them all... especially since I've already got the motor installed!

What did you adust the lash to on your RS setup?

Aaron
* Registered users of the site do not see these ads.
doubledribble is offline   Reply With Quote