View Single Post
Old 05-28-2017, 09:21 AM   #142
moby4dick
Scooby Specialist
 
Member#: 51901
Join Date: Jan 2004
Chapter/Region: Tri-State
Vehicle:
'04 WRX
WRB

Default

Just completed this install and am very happy. Now to get the V-Limited Lip! Quick tip on cutting the three notches for the upper tabs...make them a bit wider than the tab width to give you some adjustment room.

I thought I had them laid out properly, but once I popped them in the wheel well side wasn't sitting flush. You CANNOT pop the tabs out once their in, so I ended up breaking the lock portion from 2 of the 3 to get them out (the third location was okay), then widened the notches to get proper fitment. JB Welded them on the inside of the bumper once reinstalled.

Passenger side went perfectly having figured out the driver side.

Also, don't know if this "hardware kit" is still sold, so here's the P/N's of the hardware: 902510034 for the speed nut, 901000218 for the flange bolt. I think the kits had 3 sets per side.
* Registered users of the site do not see these ads.
moby4dick is offline   Reply With Quote