View Single Post
Old 01-10-2021, 02:10 PM   #5
Elbert Bass
Scooby Specialist
 
Member#: 283429
Join Date: May 2011
Chapter/Region: South East
Location: Down yonder.
Vehicle:
2016 Fuji Sunfire 03
Silver

Default

Have you put a real oil pressure gauge on the engine to see what the actual oil pressure is? I have seen older switches go bad and close at higher than specified pressure.
Have you had the oil pump off? If so did you check if the oil pump screws were loose? Did you replace the o-ring seal and reseal the oil pump?
* Registered users of the site do not see these ads.
Elbert Bass is offline   Reply With Quote