View Single Post
Old 12-01-2014, 02:28 PM   #1060
Scooby Guru
Member#: 261612
Join Date: Oct 2010
Location: Minneapolis, MN
2002 WRX - 750WHP
9.5s @ 150mph


Thanks! Taking things slow right now. It's 0F in MN so there's no rush and not much motivation to work out in a cold garage.

I did a mock up install of the FMIC. Had to trim a couple tabs off just to get it mounted. I'll likely have to do a bit more trimming before the final install.

Unfortunately the turbo to FMIC didn't line up as perfectly as I'd hoped. I can't install both at the same time due to interference but I did some Photoshop overlays.

I will probably need to get a photo from directly underneath to confirm, but this is what I'm thinking so far. Chop off the end of the compressor outlet, and weld an elbow on.

Also will have to cut down the FMIC end tank inlet an inch or two. Then hopefully it will just be a straight or possibly 45 coupler to the intercooler. Any other thoughts?

* Registered users of the site do not see these ads.
xluben is offline   Reply With Quote