View Single Post
Old 01-21-2009, 03:17 PM   #18
GrimmSpeed
NASIOC Vendor
 
Member#: 136396
Join Date: Jan 2007
Chapter/Region: MWSOC
Location: Minneapolis, MN
Vehicle:
2015 WRX, 2012 WRX,
2013 BRZ, 2006 STI

Default

I dont remember exactly but it was whatever delta told us to do so im sure that isnt that problem.

Mike


Quote:
Originally Posted by fastenova View Post
Mike,

Thanks for the reply. I just had a valve job done (valve seat grind, new stem seals, new retainers) and they adjusted the valve lash to factory spec. which is what John at Delta recommended. I was told by one member here to open them up a little bit, but I'm a little leery to do so since it's such a pain to adjust them all... especially since I've already got the motor installed!

What did you adust the lash to on your RS setup?

Aaron
* Registered users of the site do not see these ads.
GrimmSpeed is offline   Reply With Quote