View Single Post
Old 12-24-2020, 04:08 AM   #4
Scooby Newbie
Member#: 388165
Join Date: Apr 2014
Chapter/Region: Tri-State
2015 WRX
Crystal White Pearl


Originally Posted by Blktrax View Post
If you swapped stock halogens to aftermarket LED then thatís your problem. LEDs use way less power and do not operate with the same circuit load as stock bulbs. As most people are unaware and constantly blinding people with full power high beams as DRLís

If you still have stock bulbs , then the sensitivity may be set to the maximum setting turning on the headlights in pretty much any condition other than direct sunlight. Look at your owners manual how to adjust the sensitivity setting.

I already have the sensitivity down to low and from what I've read that just changes how quickly the go from off to on and vice versa. This was going on before the LED bulbs
* Registered users of the site do not see these ads.
ragnaroc is offline   Reply With Quote