View Single Post
Old 03-07-2013, 05:59 PM   #7
Scooby Newbie
Member#: 207133
Join Date: Mar 2009
Chapter/Region: TXIC
Location: Houston
2002 WRX


I am going to get a 3 port and avoid any other issues. I will be forced to run WG pressure until I re-tune my car for the 3 port BCS anyhow. I am also grabbing an OMNI 3 bar sensor, and a GM open element IAT sensor to convert over to SD. I have been studying the Carberry rom since it came out and I finally feel comfortable enough with the math and different methodology to attempt the switch.

Turd- I wanna say that the WG spring is something like half of the stock boost pressure so maybe 7-8lbs. I am not positive on that so make sure to confirm.

I found some good quality 3.5mm Vac hose on amazon, I am going to re-do all the old lines that were not changed. Do ya'll think 5ft will be enough or should I get 10ft to change out the lines involved for boost control?
* Registered users of the site do not see these ads.
TheHighestCrew is offline   Reply With Quote