View Single Post
Old 03-14-2017, 01:07 PM   #36
mrsaturn7085
Scooby Specialist
 
Member#: 375462
Join Date: Dec 2013
Chapter/Region: NWIC
Location: Portland, OR
Vehicle:
2006 Impreza WRX STI
WR Blue

Default

Did you lubricate all plates/discs during assembly? You NEED to completely cover them in 90PA (or your desired rear diff. oil).

Also, from your PM:

Quote:
Here are my numbers: A=88.37 B=2.5 C=.5 D=65.7 E=1.5 F=86.37
E = 1.85 mm (always); this is the thickness of the bellevelle washers included in the kit (part no. 5). Because you used a value of 1.5, you over-compensated on the stack height causing extremely high break-away torque.

You didn't reuse the old 1.5 mm bellevelle spring did you?

If you have your ramp assembly height (mine was 65.99 mm), I can give you the proper thicknesses to use. Assuming the same ramp assembly height as me, you should have used 2x 1.6 mm discs and 1x 1.7 mm discs per side.
* Registered users of the site do not see these ads.

Last edited by mrsaturn7085; 03-14-2017 at 01:45 PM.
mrsaturn7085 is offline   Reply With Quote