View Single Post
Old 11-25-2012, 10:13 PM   #5
PHATsuby
Scooby Guru
 
Member#: 13617
Join Date: Dec 2001
Chapter/Region: MWSOC
Location: MN
Vehicle:
2001 Legacy GT back
to stock is a project too

Default

Kind of a crappy angle but here you go. I had a hard time finding jigs myself so I can sympathize.



If I were to re-do this I would use heavier gauge material for the framing to make sure it does not move at all and then it would be an ideal jig. I bought a 3/8" thick steel plate to weld the bottom frame to to help but haven't even used this yet so it's low on the priority list.

Also I based this off of an actual OEM part and not on the car because I didn't have access to the actual car but I'd agree that it would be better to do it based off the actual engine.

hope that helps.

Ben
* Registered users of the site do not see these ads.
PHATsuby is offline   Reply With Quote