View Single Post
Old 11-22-2020, 08:22 PM   #2
NASIOC Supporter
Member#: 497893
Join Date: Feb 2019
Chapter/Region: Tri-State
Location: NJ
2011 Sti Hatch
New color coming soon.


Work In progress: Will update as I move along with the build.

Motor Build: Outfront semiclosed block, Weisco pistons, Manley rods, King bearings, Killer b oil pan, baffle, killer b pickup, Killer b water pump housing, 11mm oil pump, Ported rebuilt heads, Oem Cams, Gsc Valves, Gsc Springs, ARP 625 Studs, Cometic Gaskets, Gates timing belt kit, Grimm LW pully,

Exhaust: MAP 4-1 EL header, PLM up pipe + dump tube, Invidia deviated downpipe, Invidia N1 race,

Turbo: Blouch Dom 1.5xtr, 44mm tial EWG, Perrin turbo inlet, Cobb EBCS, Turbosmart duel port BOV, Omni 4 bar,

Engine Support: Cobb sf intake, ETS 3.5 in. FMIC, AEM speed density, Killer b upper reservoir, IAG Tgv deletes, IAG AOS, Cyl. 4 cooling mod, Perrin oil cooler retro top mount,

Fueling: AEM 340 fuel pump, Aeromotive fuel regulator, IAG Fuel rails, ID 1050x injectors

Drivetrain: ACT 6 puck, ACT streetlight flywheel,

Maintenance: sunoco 260GT 100oct, Purolator Boss oil filter, Motul 8100 x-cess 5w-40, NGK 1 step colder plugs

Suspension: Tien lowering springs, Cusco tower braces front and rear, Cusco front member, Whiteline rear control arms, Whiteline Rear Sway Bar Mount Support, Perrin F+R endlinks, Perrin front sway bar, Cusco rear sway bar


Miscellaneous: Cusco engine mounts, Cusco trans mount, Flat motors air pump delete plates, Kartboy pitch stop, Kartboy shifter bushings, Kartboy short shifter, Cusco power steering brace, Perrin master cylinder brace, Oem power steering pump and alternator, AC delete, IAG maf block off

Dress up: Perrin rad shroud, Perrin rad mounts, Perrin EBCS cover, Cobb alt. cover, rally-tech bolt kit

Interior: DAMD steering wheel, Perrin reverse lockout, Perrin si drive knob, AEM oil pressure gauge, AEM oil temp gauge, AEM AF gauge, AEM boost gauge, SMY duel gauge pod, Podi vent gauge pod, Single pod A pillar, Shift solutions e break handle, Notions and devotions shift boot, e break boot, and arm rest, Broadway mirror, Cobb weather tech mats

Exterior: Perrin shorty antenna, Perrin hella horn bracket, Hella sharp tone, Rally armor mud flaps, Jdm side badge, Jdm rain guards, inno wind fairing, Ebay all around lip kit, Grimm plate relocate, kartboy plate delete,

I'm sure I missed a few things here and there.

Thanks to Rich from Precision tuning!
Thank you GSD performance coatings!
Thanks to Dave from Headgames motorworks!
Thanks to Dane from Import image racing!
Thanks to everyone from Nasioc who sold me parts!
My dedication is real and I'm going to keep on untill I feel the car is right!
* Registered users of the site do not see these ads.

Last edited by pickleSlapOG; 12-25-2020 at 06:24 PM.
pickleSlapOG is offline   Reply With Quote