View Single Post
Old 05-31-2013, 06:09 PM   #774
Skankyfrankie
Scooby Newbie
 
Member#: 354906
Join Date: Apr 2013
Location: Moses Lake, WA
Vehicle:
07 WRX
Black

Default

If you use the tools I listed earlier the passenger side valve is not really that big of deal, just have to move a few hoses and wires to get at the valve to pipe flange, none have fluids so not too hard once you figure out how to get that bracket bolt off wiithout stripping the head, thats why the impact is critical. And clearnace wise you have to use the 1/4 drive stuff to fit under the intake runner. Also once you get it unbolted it takes a little wiggling it around just right for the valve to come out. I found a beer in one hand worked best LOL. I am sure I could never figure out how to get it back in there but who cares it's never going back on. Then just plate off the pipe, dont try to remove it until you have reason to tear into it farther.
* Registered users of the site do not see these ads.
Skankyfrankie is offline   Reply With Quote