View Single Post
Old 07-05-2020, 07:59 PM   #88
Dash_Martino
Scooby Newbie
 
Member#: 78728
Join Date: Jan 2005
Chapter/Region: Tri-State
Location: Jim Chunk, PA
Vehicle:
04 STi
PSM

Default

So I installed the whiteline bushings in my control arm and tried to press my control arm back in, but the new bushings wont squeeze in between the subframe. So I got some allthread and a few nuts and some washers. I used the nuts and the all thread to expand the joint where the control arm squeezes in.


Things were still tight so I used the jack from the trunk to help squeeze it in.


Now onto my axle nut, which so far has broken two breaker bars.
* Registered users of the site do not see these ads.
Dash_Martino is offline   Reply With Quote