View Single Post
Old 12-10-2012, 04:53 PM   #4251
Scooby Specialist
Member#: 12391
Join Date: Nov 2001
Chapter/Region: NESIC
I did her 5 times
then 7 times, then 5 more


Originally Posted by The Phenx View Post
Never run stud u-joint straps they are crap.

U-bolts are far superior... just make sure you mod the yoke right.

HOWEVER... if your u-joint is fitting properly they serve almost no function, and see almost 0 force.

I think you might have a seccondary issue... either excessive driveline angle, a wallowed out yoke, or a malformed u-joint. As torque related breakage should be in the joint or the shaft tubing.
The angle is fine, and the axle is pitched perfectly.

I came to the same conclusion, and replaced the u-joint while I was at it. If it was a fault in the yoke or joint, it should be gone now.
* Registered users of the site do not see these ads.
Hypernoodle is offline   Reply With Quote