View Single Post
Old 03-27-2013, 04:42 PM   #4776
MRF582
Scooby Guru
 
Member#: 48219
Join Date: Nov 2003
Chapter/Region: MAIC
Location: Pittsburgh, PA
Vehicle:
. Always drive
the race line .

Default

Where can I buy the male and female parts to make a good weather resistant connector assembly? I need to make a few 2 pin connector assemblies.

Mike, I know you had mentioned getting the Metripack stuff. Do you need any special tools to assemble them? Is Ballengers the best place to get them still? Anything local?

Should I just buy a set of these?
http://www.bmotorsports.com/shop/pro...oducts_id/1010
http://www.bmotorsports.com/shop/pro...roducts_id/748
Should I get this crimping tool too? http://www.bmotorsports.com/shop/pro...roducts_id/362

IByoumomhasbothmaleandfemaleparts
* Registered users of the site do not see these ads.

Last edited by MRF582; 03-27-2013 at 04:52 PM.
MRF582 is offline   Reply With Quote