View Single Post
Old 12-01-2020, 06:13 PM   #5
Elbert Bass
Scooby Specialist
Member#: 283429
Join Date: May 2011
Chapter/Region: South East
Location: Down yonder.
2016 Fuji Sunfire 03


Originally Posted by Booki View Post
Ended up being wheel bearings.

Car is nice and quiet now, however Its now triggered P0500 - wheel speed sensor A.

How sensitive are those sensors? Thinking some grease might have gotten on some
If there were metal filings in the grease it is possible.
The reluctor magnets are imbedded in the inner face of the bearing - any metal filings or rust stuck there will cause problems.
Did you remove the ABS sensor before removing the bearing? If not you may have broken the tip of the sensor.

If you used an aftermarket wheel bearing it may not have had the reluctor imbedded in the bearing. This is very rare, but not uncommon if it was a real cheap part.
* Registered users of the site do not see these ads.
Elbert Bass is offline   Reply With Quote