View Single Post
Old 04-07-2007, 09:35 AM   #1
06BlackSTIwith550WHP
Scooby Specialist
 
Member#: 116325
Join Date: May 2006
Chapter/Region: Tri-State
Vehicle:
2006 BLACK STI
UR Rotated GT30R

Default air/fuel install HELP NEEDED NOW

So I finally have a free time to install my NGK AFX air fuel gauge. But I am a complete noob at wiring, I have a little experience sodering but I don't want to go rip apart the electrical system in my car. so heres the deal the NGK AFX has a big Y shaped assortment of wires already connected. At one point of the Y their is a sensor, at another end their is the gauge and at the last end their are two wires (red and black) that have like a "fork" off the end of the wires. I already have a bung for the sensor, so is their any place to put these "forks" that I wont have to cut, or splice anything? Where is the best place to wire them too? thank you very much your help is greatly appreciated, and I need help asap so please respond
* Registered users of the site do not see these ads.

Last edited by 06BlackSTIwith550WHP; 04-07-2007 at 09:58 AM.
06BlackSTIwith550WHP is offline   Reply With Quote