View Single Post
Old 04-08-2010, 02:50 AM   #2
gene4ace
Scooby Newbie
 
Member#: 108210
Join Date: Feb 2006
Chapter/Region: SCIC
Default

yup just get the ecu connectors from a legacy 90-94(some honda and mitsu also) and just merge the harness pins from one connector to the next, also adding the 7-8 wires to control the rest of the new stuff an ej22t has

4th wire for throttle sig, knock sensor, 3 wires for map sensors , 2 wires for boost control, maybe another one but im still in process myself of this swap, also the cam/crank sensor wires get switched over on the turbo models

ps also an Ignition signal to the keep alive memory pin with a diode or else the car will not start
* Registered users of the site do not see these ads.
gene4ace is offline   Reply With Quote