View Single Post
Old 05-03-2005, 05:09 AM   #2
PHATsuby
Scooby Guru
 
Member#: 13617
Join Date: Dec 2001
Chapter/Region: MWSOC
Location: MN
Vehicle:
2001 Legacy GT back
to stock is a project too

Default

did you happen to look a few posts down from yours.... Slack is putting one is his GC, and i am putting one into my legacy and turboing it. so with our powers combined you will prob be able to figure out what you can do

In my opinion you need to strengthen the internals to turbo it, which is what i am doing. its current 10.7:1 compression ratio would make anything other than low boost impossible basically. i will be doing new rods and lower compression pistons, most likely 8.7-9:1.

if you wanted to try and turbo the NA block i would guess you could boost about 6psi with a good tune on pump and that would give you about an 80-100hp boost(sorry dont know Kw conversion). I will be going for 500whp daily on pump

search under my name in the legacy forum to pull up my thread. also you can read slack's as well. He will prob be your GC resource and i can be your engine info and turbo resource

good luck. let me know if you have any questions.

Ben
* Registered users of the site do not see these ads.
PHATsuby is offline   Reply With Quote