View Single Post
Old 04-15-2014, 11:46 PM   #2
MrRicH
Scooby Specialist
 
Member#: 150452
Join Date: Jun 2007
Chapter/Region: AKIC
Location: Anchorage, Alaska
Vehicle:
2016 Subaru WRX STi
Ice Silver Metallic

Default



Once separated, here is a quick shot of the chrome housing. Hopefully the last...



The LED "C" and the amber reflector is easily removed from the housing. Then spray lightly and evenly over the assembly using a matte black ( or color of your choice ) primer which bonds to plastic ( some of these paints will not bond evenly or drop when applied ) it took me around 1 hour for this part to make sure the coats were even, and I wasn't missing parts within the housing ( easy to do )



Quick shot of the housing re-assembled before being inserted into the headlamp. I chose to re-insert the amber reflects as I actually think they look nice.



And the re-assembled assembly



Now, it's just putting everything back together again.

An easy tip! When putting the bumper back on, place the upper grill area on first and insert the two farthest 10mm bolts, this will hold it aligned and in place as you properly secure the sides, as well as make sure the tabs along the bottom are inserted correctly!




Here is a shot of the finished product




Front shot with the HID's on



So, being my first write up on something, I feel I covered everything needed. Some minor details may be missing, but nothing important or anything which should cause different results.
Please feel free to message and/or comment if you have any questions in regards to this write up. Otherwise, enjoy!

-Rich

<End of part 2>
* Registered users of the site do not see these ads.
MrRicH is offline   Reply With Quote