View Single Post
Old 09-13-2019, 08:55 AM   #1
roadtrip1098
Scooby Newbie
 
Member#: 185688
Join Date: Jul 2008
Chapter/Region: NESIC
Location: Maine
Vehicle:
2006 STi
WR Blue

Default Subaru Select Monitor 3 Help

Hello all,
Recently replaced my steering rack '06 STi. Got the dreaded steering angle sensor faults. Did a ton of searching and the consensus was that SSM3 could reset the sensor. I purchased the VXDIAG box and got everything working, but cannot find the option to recalibrate the steering angle sensor. I checked the output on the sensor, it sits at zero and the numbers go up and down as the wheel turns, but if I go to full lock the sensor jumps to iirc 2049 and then stays there.
If anyone has run into this or knows how to operate the ssm3 to recalibrate it, I would appreciate any input.
* Registered users of the site do not see these ads.
roadtrip1098 is offline   Reply With Quote