View Single Post
Old 09-19-2008, 09:22 PM   #5
KONKILR
Scooby Specialist
 
Member#: 3190
Join Date: Dec 2000
Chapter/Region: MAIC
Location: Flintstone,md.
Vehicle:
2004 Impreza TS and
the Suxass racing mobile!

Default

I have them on my autocross car. This car has been known to have enough grip to snap coilovers in half. I have had zero issues with my kit, but I always overtorque everything. If the pinch bolt is tight there should never be any possible issue of them pulling out since there is a groove that the bolt goes through in the ball joint.

There should be minimal difference noticed in the performance over stock. The whole point of the kit is to correct the control arm angle on a lowered car. The control arms are supposed to have a slightly downward angle so that under suspension compression the camber increases. Thus increasing grip in a hard turn. The improvements will be barely noticeable on daily use.

jake
* Registered users of the site do not see these ads.
KONKILR is offline   Reply With Quote