View Single Post
Old 10-20-2020, 01:49 AM   #108
blueberryapple
Scooby Newbie
 
Member#: 519370
Join Date: Oct 2020
Chapter/Region: SCIC
Location: Los Angeles, CA
Vehicle:
2020 WRX
WRB

Default

Quote:
Originally Posted by qnzfinestflip View Post
So, found his post on iwsti explaining what wires i need to move and tap into. I was only able to move pin#14(D83 plug) to pin#25 slot and passenger mirror was able to fold close. I was not able to finish up since i ran out of time. So, im guessing it should be wire like this:

Driver side:
-D84 plug
remove pin#14(Light green) and tap into pin#25
-D15 plug
pin#6(Black), cut and run a new wire and tap into pin#24(Blue with red stripe) on D84 plug

Passenger side:
-D83
remove pin#14(Light green) and re pin to pin#25(blank spot from factory)
-D5
pin#6(Black), cut and run new wire and tap into pin#24 on D83 plug

Then the mirrors would be able to fold open and close by pressing the switch on the panel. Hope this sounds correct or hope you can chime in and help out
Yup you're spot on. I DMed him last week and he said pretty much the same thing. Going to try this mod out this weekend or the next. Are you also planning on installing the auto folding module?
* Registered users of the site do not see these ads.
blueberryapple is offline   Reply With Quote