View Single Post
Old 11-15-2010, 03:02 PM   #9
jrank3792
Scooby Specialist
 
Member#: 219756
Join Date: Aug 2009
Chapter/Region: Tri-State
Location: Buffalo
Vehicle:
06 WRX TR
OBP

Default

IF YOU HAVE A 2005 OR DEFINITELY A 2006 AND PROBABLY A 2007 MODEL, YOU CAN EFFECTIVELY UNLOCK THE TERMINAL FROM THE RELAY BLOCK FOR THIS WIRE AND NOT HAVE TO CUT IT, BUT TO MAKE THIS WORK YOU WOULD HAVE TO GET A LOCK-TYPE FEMALE TERMINAL TO PLUG INTO THE RELAY BLOCK THAT WOULD BE ATTACHED TO YOUR NEW 'YELLOW' WIRE THAT YOU'RE GOING TO USE.

THIS IS DUE TO A DESIGN CHANGE TO THE RELAY BLOCK.

Cut this wire approximately 2-inches from the back of the relay block AND install a crimp-on male bullet connector.

Install a crimp-on female bullet connector to the other side of the wire that was just cut - this is the "car side" Why? Because if for some reason you want to restore the foglamps to their original set-up, you can. Also, you don't want a live circuit hanging out behind the dash as well.


This section confuses me
* Registered users of the site do not see these ads.
jrank3792 is offline   Reply With Quote