View Single Post
Old 01-13-2011, 11:18 PM   #14
kh15
Scooby Specialist
 
Member#: 132400
Join Date: Nov 2006
Location: New Orleans
Vehicle:
2006 WRX

Default

Quote:
Originally Posted by jrank3792 View Post
IF YOU HAVE A 2005 OR DEFINITELY A 2006 AND PROBABLY A 2007 MODEL, YOU CAN EFFECTIVELY UNLOCK THE TERMINAL FROM THE RELAY BLOCK FOR THIS WIRE AND NOT HAVE TO CUT IT, BUT TO MAKE THIS WORK YOU WOULD HAVE TO GET A LOCK-TYPE FEMALE TERMINAL TO PLUG INTO THE RELAY BLOCK THAT WOULD BE ATTACHED TO YOUR NEW 'YELLOW' WIRE THAT YOU'RE GOING TO USE.

THIS IS DUE TO A DESIGN CHANGE TO THE RELAY BLOCK.

Cut this wire approximately 2-inches from the back of the relay block AND install a crimp-on male bullet connector.

Install a crimp-on female bullet connector to the other side of the wire that was just cut - this is the "car side" Why? Because if for some reason you want to restore the foglamps to their original set-up, you can. Also, you don't want a live circuit hanging out behind the dash as well.


This section confuses me
also confused....
* Registered users of the site do not see these ads.
kh15 is offline   Reply With Quote