View Single Post
Old 04-24-2004, 11:40 PM   #3
Unabomber
👏 Big Ron 👏
Moderator
 
Member#: 18062
Join Date: Apr 2002
Chapter/Region: MAIC
Location: I can save you a ton of cash
Vehicle:
on car parts so PM
me b4 j00 buy

Default

Did you use a 1/2" drive breaker bar on it? This is the "proper" tool for it. Just slip the 1/2" square socket tip into the diff bolt "hole". If you can't get enough leverage with it, a pipe section slipped over the end should do it. The diff bolt IS a bear, so don't fear getting violent with it.
* Registered users of the site do not see these ads.
Unabomber is offline   Reply With Quote