View Single Post
Old 05-25-2016, 09:49 AM   #184
KillerBMotorsport
NASIOC Vendor
 
Member#: 198281
Join Date: Dec 2008
Chapter/Region: MAIC
Location: Virginia
Vehicle:
2005 WRX/STi
WRB of course

Default

Instruction set I just sent to a customer...

It takes some wrestling and patience, but it should get in there. Remove the mounting brackets on each side. Install the throttle body coupler on the throttle body first. You may also want to remove the MAP sensor plug that is on the top center and facing back on the manifold, and the hose that runs along the backside. Basically anything you can easily get to, remove or move to the side, to give you more wiggle room. From there you want to get the throttle body side on first, then the charge-pipe side. If you're using the OEM charge pipe, you may need an assistant to hold it out of the way.
* Registered users of the site do not see these ads.
KillerBMotorsport is offline   Reply With Quote