View Single Post
Old 11-27-2012, 05:45 AM   #1
Scooby Newbie
Member#: 260400
Join Date: Oct 2010
Chapter/Region: SWIC
Location: Avondale, AZ
2007 STI
Urban Gray Metallic

Default P0502 while using cruise control.

Driving home the other night on the highway with cruise control set. Everything seemed fine then the car sort of jolted, which killed the cruise control and then check engine light came on. Drove to AutoZone, car drove fine no limp mode, pulled the code and came up with a P0502 Vehicle Speed Sensor 'A' Low Input. Had the code cleared, drove home, and a round town yesterday and the car still seems to drive OK and no check engine light although I haven't used the cruise control since. I have done some research on here and found similar stories but their cars pulled other codes along with the P0502 and theirs went into limp mode. So my question, has anyone else experienced this and what was their fix? Does it sound like my speed sensor is bad also even thought I had no other codes and no limp modes?
* Registered users of the site do not see these ads.
az07sti is offline   Reply With Quote