|
|
|
|
Thread Tools | Display Modes |
04-01-2005, 09:36 PM | #1 |
Scooby Newbie
Member#: 37008
Join Date: May 2003
Chapter/Region:
SCIC
Location: Los Angeles
Vehicle:2005 WRX Sedan (STX) Crystal Grey -TeamBrew- |
Rescaling X&Y Axis (Ecutek/StreetTuner)
When rescaling the x and y axis on the ST maps, is it ok to have, different scales for relating axis on the maps?
Is it ok to have the knock correction load axis slightly different than the Base ignition map load axis? Do any of the map axis need to match up? Does the ECU look up each map seperately and then add or subtract values against each other, or does the ecu need to look up common cell sites to work effectively? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MAF rescaling | Freon | Commercial ECU Reflashes | 0 | 05-26-2006 05:32 PM |
Can the car withstand 400WHP with a good tuning (with ProTuner or StreetTuner)? | Ozer | Engine Management & Tuning | 13 | 11-11-2005 10:45 AM |
New Coldplay Album X&Y out today | PhatMatt | Off-Topic | 49 | 08-26-2005 03:53 PM |
05 WRX MAF Calibration & Fuel Trim (Ecutek/StreetTuner) | buzz313th | Engine Management & Tuning | 3 | 04-02-2005 04:55 PM |
Maf Limitations (Ecutek/StreetTuner) | buzz313th | Engine Management & Tuning | 2 | 04-02-2005 08:13 AM |