|
|
|
|
Thread Tools | Display Modes |
|
01-07-2008, 12:12 AM | #1 |
Scooby Guru
Member#: 32459
Join Date: Feb 2003
Chapter/Region:
Tri-State
Location: NY
Vehicle:02 WRX VF34 (SOLD) Junior Tuned 301whp |
Installing AEM UEGO in a single pod (cup) - best way to hide wiring?
I plan to install AEM AFR gauge using a 52mm single pod (cup) using a 3M tape. Any way to make the wiring appear as "OEM" as possible by placing the gauge in a certain location? Any suggestion is appreciated. Unfortunately, I can't lose OEM 3 gauge pack as yet.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Best way to tap wires in the ECU? | BBBsti LTD | Electrical & Lighting | 3 | 10-12-2008 08:00 PM |
Best way to mount subiegal's single gauge pod? | criz | Interior & Exterior Modification | 13 | 07-05-2005 11:50 PM |
Best way to run wire (pic inside) | ludecrous | Electrical & Lighting | 9 | 06-30-2005 10:53 AM |
Best way to route wires on column mount boost gauge? | drees | Interior & Exterior Modification | 11 | 05-08-2003 06:24 PM |
Best way to get amp wires to x-over in doors?? | fastsubie | Car Audio, Video & Security | 4 | 09-29-2002 10:12 PM |