|
|
|
|
Thread Tools | Display Modes |
07-21-2010, 12:52 AM | #1 |
Scooby Specialist
Member#: 235744
Join Date: Jan 2010
Chapter/Region:
VIC
Location: Burnaby, BC
Vehicle:2000 Forester STi White - JDM yo! |
UEL headers , CEL
i've been researching for different UEL header setups for my07 2.5i and was noticing that people are getting CELs and some dont.
Is there a good setup to avoid getting CEL? if you're not getting a CEL on your 2.5i, can you post your setup? thanks! -JC **my bad, if this has been asked a million times, i swear i searched! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Possible Complete UEL Header Solution for P0420 CEL | nti_hazard88 | Normally Aspirated Powertrain | 61 | 01-04-2024 07:03 PM |
CEL error after installing Borla UEL headers? | MerrosFox | Normally Aspirated Powertrain | 5 | 02-05-2010 03:25 PM |
FS NY: Heat coated Fujitsubo EL header, Gruppe-S UEL header, STi uppipe | garface | Engine/Power/Exhaust | 27 | 05-07-2009 11:00 AM |
el headers for uel headers | gostdog | Private 'Wanted' Classifieds | 8 | 12-02-2008 10:46 AM |
NJ: GC jet-hot coated borla UEL headers and stock headers | M E R C U R Y | Tri-State Area Private Classifieds | 1 | 05-12-2008 01:58 PM |