|
|
|
|
Thread Tools | Display Modes |
|
04-08-2009, 02:41 PM | #1 |
Scooby Specialist
Member#: 199206
Join Date: Jan 2009
Chapter/Region:
South East
Location: Ft Stewart, GA
Vehicle:2002 WRX wagon EJ257 PSM |
ignition key ring light install?
anyone know of a write up to install an ignition key ring light into my 2002 WRX sedan?
help, please. and yes, i've searched.. |
04-08-2009, 04:01 PM | #2 |
Scooby Specialist
Member#: 153465
Join Date: Jul 2007
Chapter/Region:
South East
Location: f l a
Vehicle:2004 Suzuki GSXR 600 WRX now FS! |
02 and 03's dont have them stock? Never knew that... 04+ all have em.
Try searching for an 04+ ignition key ring then and just replace it with current one, should slide right over the ignition key cylinder just fine. |
04-08-2009, 04:33 PM | #3 | |
Scooby Specialist
Member#: 199206
Join Date: Jan 2009
Chapter/Region:
South East
Location: Ft Stewart, GA
Vehicle:2002 WRX wagon EJ257 PSM |
Quote:
i have the ring, i just need to know which wires to tap into. |
|
04-08-2009, 04:35 PM | #4 |
Scooby Newbie
Member#: 157016
Join Date: Aug 2007
Chapter/Region:
TXIC
Location: Fort Worth, TX.
Vehicle:02 WRX - MBP Invisible... |
My 02 has a ring, but as far as I know, they don't illuminate! Does yours have a bulb in it?
EDIT: I see you found one that does. Maybe you can splice off an interior light that lights up on entry? |
04-08-2009, 04:37 PM | #5 |
Scooby Specialist
Member#: 180710
Join Date: May 2008
Chapter/Region:
TXIC
Location: Corpus Christi
Vehicle:2006 Sti WRB WFC# 229 |
|
04-08-2009, 04:39 PM | #6 |
Scooby Specialist
Member#: 199206
Join Date: Jan 2009
Chapter/Region:
South East
Location: Ft Stewart, GA
Vehicle:2002 WRX wagon EJ257 PSM |
I'm guessing maybe there is a harness that can be tapped into?
|
04-08-2009, 04:36 PM | #7 |
Scooby Specialist
Member#: 180710
Join Date: May 2008
Chapter/Region:
TXIC
Location: Corpus Christi
Vehicle:2006 Sti WRB WFC# 229 |
How many wires run off of it? Im assuming its power and ground. If so you can get an add a cuircuit from autozone and run it from an accessory power spot that lights up when the interior lights come on, then ground it to the negative terminal on your battery or bare metal somewhere.
|
04-08-2009, 04:42 PM | #8 |
Scooby Specialist
Member#: 153465
Join Date: Jul 2007
Chapter/Region:
South East
Location: f l a
Vehicle:2004 Suzuki GSXR 600 WRX now FS! |
The ones that have it from factory, its connects to a harness with only 2 wires being used. LEDs use two wires: power and ground. Ground is self explanatory. Power, splice it into a switched 12 volt wire. All set.
|
04-08-2009, 04:58 PM | #9 |
Scooby Specialist
Member#: 92141
Join Date: Jul 2005
Chapter/Region:
Tri-State
Location: in a guardrail near you
Vehicle:2014 GT-NC-PRHT Zeal Red. |
you searched, eh?
did you see this? keylight? or this even? Interior Color Change Tutorial: Key Ring (which gets to your question around post 15) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help Needed: Key Ring light and Power Door Lock Not Working | Linkseal | Electrical & Lighting | 2 | 03-24-2010 06:50 PM |
key ring light, radio and clock are not working | moose00015 | Newbies & FAQs | 5 | 03-23-2010 12:29 PM |
Key Ring Light | Spore | Interior & Exterior Modification | 1 | 05-23-2008 02:49 PM |
lighted ignition key hole surround | TerenceT | Interior & Exterior Modification | 11 | 08-25-2002 03:02 AM |
Lighted ignition key ring | V6 | Interior & Exterior Modification | 4 | 11-01-2000 05:49 AM |