key ring light, radio and clock are not working

moose00015 · 03-05-2010, 10:45 AM

I attempted to change the bulb to an led this morning. I had tested it before I went to reinstall it in the key ring itself. It worked then. I installed it and now the thing doesn't work. I pulled it out and swapped leds with the cigarette lighter one which works. Oddly enough the first led from the key ring works in the cigarette lighter, but the one from the cigarette lighter doesn't work in the key ring. Is there a fuse I could have possibly blow somewhere along the way?

Thanks

ETA: Now my radio and clock do not work either. Any thoughts?

* Registered users of the site do not see these ads.

99subi · 03-05-2010, 11:49 AM

fuse.

CKxx · 03-05-2010, 11:51 AM

Quote:

Originally Posted by 99subi

fuse.

This. Or that one led simply blew out or is defective.

moose00015 · 03-05-2010, 12:04 PM

I just checked the fuses after checking to see if my dome lights worked. They didn't and I found I blew the clock room under the hood. I need to run and grab more fuses.

Craig, I had switched the LEDs to check that first. I thought I blew the LED at first too.

Thanks for the help.

Linkseal · 03-23-2010, 12:25 AM

^ any update?
I got the same problem, instead, my Key ring light and center door lock not working, fuse for sure is fine...

06AZREX · 03-23-2010, 12:29 PM

It should be a fuse problem, just remember that a fuse can "look" good but in fact be bad.

03-05-2010, 10:45 AM	#1
moose00015 Scooby Specialist Member#: 180924 Join Date: May 2008 Chapter/Region: MAIC Location: West Chester, PA Vehicle: 2017 Forester	key ring light, radio and clock are not working I attempted to change the bulb to an led this morning. I had tested it before I went to reinstall it in the key ring itself. It worked then. I installed it and now the thing doesn't work. I pulled it out and swapped leds with the cigarette lighter one which works. Oddly enough the first led from the key ring works in the cigarette lighter, but the one from the cigarette lighter doesn't work in the key ring. Is there a fuse I could have possibly blow somewhere along the way? Thanks ETA: Now my radio and clock do not work either. Any thoughts? * Registered users of the site do not see these ads. Last edited by moose00015; 03-05-2010 at 11:10 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help Needed: Key Ring light and Power Door Lock Not Working	Linkseal	Electrical & Lighting	2	03-24-2010 06:50 PM
Hvac controls are not working after radio install.	Crow-sti07	Car Audio, Video & Security	3	07-07-2009 01:46 PM
Radio and clock stopped working. Help!!!	02turbosuby	Electrical & Lighting	3	11-30-2006 02:13 PM
Radio and clock not working after cluster install	jdm_wrx	Electrical & Lighting	1	12-12-2005 04:56 AM
speedo and tach are not working properly	...lostwrx	Newbies & FAQs	7	11-07-2005 03:21 PM

03-05-2010, 11:49 AM	#2
99subi Scooby Guru Member#: 78118 Join Date: Dec 2004 Chapter/Region: Tri-State Location: Westchester NY Vehicle: 2002 Corvette coupe 05 Legacy	fuse.

03-05-2010, 12:04 PM	#4
moose00015 Scooby Specialist Member#: 180924 Join Date: May 2008 Chapter/Region: MAIC Location: West Chester, PA Vehicle: 2017 Forester	I just checked the fuses after checking to see if my dome lights worked. They didn't and I found I blew the clock room under the hood. I need to run and grab more fuses. Craig, I had switched the LEDs to check that first. I thought I blew the LED at first too. Thanks for the help.

03-23-2010, 12:25 AM	#5
Linkseal Scooby Guru Member#: 102329 Join Date: Dec 2005 Chapter/Region: VIC Location: Canucks Vehicle: 05 AW Piggy Gone 11 SP TOM'S IS-F	^ any update? I got the same problem, instead, my Key ring light and center door lock not working, fuse for sure is fine...

03-23-2010, 12:29 PM	#6
06AZREX Scooby Specialist Member#: 132244 Join Date: Nov 2006 Chapter/Region: NWIC Location: Everett Vehicle: 2006 OBP WRX 2006 BMW 325i	It should be a fuse problem, just remember that a fuse can "look" good but in fact be bad.