|
|
|
|
Thread Tools | Display Modes |
02-22-2011, 10:09 AM | #1 |
Scooby Newbie
Member#: 274245
Join Date: Feb 2011
Chapter/Region:
Tri-State
Location: FairView NJ
Vehicle:02 WRX Silver |
EG20R vs EG20G(wrx engine)
Hey guys what if i just used the long block and the tranny will all my eg20g censors, will match up with my harness or these two engine are completely different?
* Registered users of the site do not see these ads.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Then & Now: 2000rs vs 2011wrx | skidplatez | General Community | 18 | 02-24-2011 12:42 PM |
Gauge Pod Installed (except for oil and vacuum on engine) | Aspen_2.5RS | Interior & Exterior Modification | 10 | 06-02-2001 01:40 PM |
Seeking California LEGAL Knowledge (NA Engine) | ndmorespd | Normally Aspirated Powertrain | 17 | 05-20-2001 12:21 AM |
Intake and CE (Check Engine) Light | Longitude | Normally Aspirated Powertrain | 3 | 02-17-2001 09:24 PM |
Lets see if I got it all covered... (Breaking in an engine) | ba_feitl | Newbies & FAQs | 5 | 02-02-2001 12:58 AM |