|
Brakes & Suspension Forum sponsored by The Tire Rack |
|
|
|
Thread Tools | Display Modes |
03-31-2019, 11:35 AM | #1 |
Scooby Newbie
Member#: 320545
Join Date: May 2012
|
Steering column knuckle fitment
I swapped a 2015 rack into my 2001 rs I had a 2011 knuckle but was damaged so I'm trying to figure out what year knuckle(joint) I could use to complete my swap any help is greatly appreciated
* Registered users of the site do not see these ads.
|
03-31-2019, 11:38 AM | #2 |
Scooby Guru
Member#: 71875
Join Date: Oct 2004
Location: Montana
|
I think you will need to have two cut and welded together. Pretty sure the 2001 has the older, coarser spline count. A company called L&E used to make them, not sure they still do.
|
03-31-2019, 12:00 PM | #3 |
Scooby Newbie
Member#: 320545
Join Date: May 2012
|
I'm fabricating one to work by cutting the welds off then popping off the end then I'm welding it to my rs knuckle but I need to know the which would fit the 2015 sti rack
|
04-01-2019, 10:13 AM | #4 |
Scooby Specialist
Member#: 175624
Join Date: Mar 2008
Chapter/Region:
MWSOC
Location: Wichita, KS
Vehicle:0304 WRX WRX SY WRB |
Any GD/GR knuckle or the VA STi knuckle will have the splines to match the 2015 rack. You should be able to cut the end off of any of those
|
Thread Tools | |
Display Modes | |
|
|