|
|
|
|
Thread Tools | Display Modes |
08-13-2018, 03:13 PM | #1 |
Scooby Newbie
Member#: 154939
Join Date: Jul 2007
Location: Phoenix
Vehicle:2019 WRX Limited WR Blue Pearl |
What is this?
I am replacing my short block because of a spun bearing and I cannot get the connector off this from my old engine.
Does anyone know what this is so I can order a new one? It looks like it has a T on the end of it and 2 hoses are connected to it.
* Registered users of the site do not see these ads.
|
08-13-2018, 03:32 PM | #2 |
Scooby Newbie
Member#: 425688
Join Date: Jul 2015
Chapter/Region:
MAIC
Vehicle:2006 WRX Word Rally Blue |
Looks like where the PCV valve connects up to the block. It has the y and hoses attached to it that you described.
|
08-13-2018, 04:15 PM | #3 | |
NASIOC Supporter
Member#: 30669
Join Date: Dec 2002
Chapter/Region:
Tri-State
Location: USA, North NJ, 07456
Vehicle:1998 Legacy 2.5GT Silver Sleeper BK, 5MT |
Quote:
The rubber like hose that fits on that nipple gets hard with age, seems more like plastic than rubber. A hair dryer on the hose that fits there may allow getting it off. If you yank too hard or bend it, the hose WILL break off. Dealer is the best source and not too expensive. |
|
08-13-2018, 10:30 PM | #4 |
Scooby Newbie
Member#: 154939
Join Date: Jul 2007
Location: Phoenix
Vehicle:2019 WRX Limited WR Blue Pearl |
ok, you guys are geniuses.. now the hard part. So I have a 2.5i and it looks like in this image it isn't a hose, which is how mine is, it's a metal fitting. I have been searching for hours on Subaru's Website and I am not sure if I should just get this:
or if I should try to find the original metal adapter shown here: |
Thread Tools | |
Display Modes | |
|
|