|
|
|
|
Thread Tools | Display Modes |
06-13-2018, 09:12 PM | #1 |
Scooby Newbie
Member#: 407226
Join Date: Nov 2014
Location: Jackson, Wy
Vehicle:2011 Outback Pearl White |
2.5 Outback Exhaust Question
Hey NASIOC gang.
So I installed a Nameless Performance axle back exhaust on my 2011 2.5 Outback today, and absolutely love it. While my friend and I were doing it, was wondering about a either header back exhaust or a cat back exhaust. To the best of my knowledge, cat back is out due to there not being a break in the exhaust system. Anyone know of places that fab header backs for the newer Generation outbacks, or would it be a fully custom job to get a new exhaust from the headers to the Nameless axle back? If so, what are some good sources of pipes/rods and such (preferable aluminum) to make one, if it is at all reasonable. I have friends that have TIG welders and pipe benders and would want to help me with the project, so thats not an issue. Just wondering if it is feasible to do. Another thought is there any header backs from another boxer engine that would work with some slight modification? Should note that have a lot of rust on my exhaust system, so thats one reason for me wanting to take this project on.
* Registered users of the site do not see these ads.
|
06-14-2018, 11:40 AM | #2 |
Scooby Specialist
Member#: 265783
Join Date: Dec 2010
Chapter/Region:
RMIC
Location: the fern behind the porn couch
Vehicle:2017 Forester XT Niner ROS 9 |
any decent exhaust shop can fab you up a mid pipe. just go with steel. aluminum is not going to like the high heat and will not last.
|
Thread Tools | |
Display Modes | |
|
|