|
![]() |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Scooby Newbie
Member#: 488985
Join Date: Aug 2018
Chapter/Region:
MAIC
Location: pa
Vehicle:2009 wrx dgm |
![]() While I was putting on my ebcs I noticed my connector to my map sensor was shredded. Its likely been like this since the dealer screwed up and shredded my serpentine belt but I want to make sure it's still safe to drive with a map that might be reading poorly.
![]() ![]()
* Registered users of the site do not see these ads.
|
![]() |
![]() |
![]() |
#2 |
Scooby Newbie
Member#: 521544
Join Date: Jan 2021
Vehicle:2018 Forester XT |
![]() Has the car been giving you any reasons to believe the MAP is faulty?
|
![]() |
![]() |
![]() |
#3 |
Scooby Newbie
Member#: 521544
Join Date: Jan 2021
Vehicle:2018 Forester XT |
![]() Actually taking a look at the pictures you posted now. I would just replace the plug with a new one.
|
![]() |
![]() |
![]() |
#4 |
Scooby Newbie
Member#: 521544
Join Date: Jan 2021
Vehicle:2018 Forester XT |
![]() iwireservices.com sells replacements btw
|
![]() |
![]() |
![]() |
#5 |
Scooby Guru
Member#: 487
Join Date: Nov 1999
Chapter/Region:
TXIC
Location: Greatwood/Sgrlnd
Vehicle:1998 /2005 STunIcorn Acadia Green RS-T |
![]() ^^^^^holy Crap what a service/vendor
My build was stopped dead until I found someone that would clip 1Coil Pack pigtail off a $400 harness https://www.iwireservices.com/produc...eplacement-kit Site saved!!!! |
![]() |
![]() |
![]() |
#6 |
Scooby Newbie
Member#: 488985
Join Date: Aug 2018
Chapter/Region:
MAIC
Location: pa
Vehicle:2009 wrx dgm |
![]() Yea it's the plug, I've got a replacement from i-wire but it's going to take a while to get here and this is my dd. I was wondering if the map sensor plays an important part in fueling or not. Key on engine off the map reads the same as barometric on my ap so it still does work, it might just cut out at some point.
|
![]() |
![]() |
![]() |
#7 |
Scooby Newbie
Member#: 521544
Join Date: Jan 2021
Vehicle:2018 Forester XT |
![]() I wouldn't worry about it too much dude
|
![]() |
![]() |
![]() |
#8 |
Scooby Newbie
Member#: 363007
Join Date: Jul 2013
Chapter/Region:
MWSOC
Location: MO
Vehicle:2008 STI Black |
![]() You'll likely get a CEL if it disconnects, I'd just tape it up until the replacement plug comes in.
|
![]() |
![]() |
![]() |
#9 |
Scooby Newbie
Member#: 488985
Join Date: Aug 2018
Chapter/Region:
MAIC
Location: pa
Vehicle:2009 wrx dgm |
![]() Yea I taped it up and haven't got a cel yet so I think I'm good for now.
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|