Hey guys, my name is Tom and I have been using Carberry/Romraider to tune my vehicle for about a year now. I started with a basic setup and have been slowly adding parts and fine tuning everything.
I recently installed an FP Green HTZ on my 02 WRX and complimented it with Five-O Motorsports Black Ops 1300cc injectors. My issue is that with the suggested latencies, scalar, and minimum pulsewidth my idle afrs are around 10.5-11:1. I have tried using low pulsewidth compensation to no avail, as putting negative fueling into the compensation table results in no changes in afr. I have my minimum pulsewidth set to .5ms for now to idle and cruise at 14.7:1, but it obviously results in hesitation/misfiring.
My injector settings are as follows in romraider:
Scalar: 1170cc
Latency: [email protected], 1.64@9v, [email protected], .61@14v, [email protected]
Minimum Pulsewidth: .5ms
Max Base Pulsewidth: 3ms
I am on stock fuel rails, and have an AEM320 fuel pump. I'm just hoping I can get some guidance on learning to tune these injectors, or if anyone has data for me to input that would be helpful. Thank you.