|
|
|
|
Thread Tools | Display Modes |
10-06-2012, 12:49 PM | #1 |
Scooby Specialist
Member#: 332887
Join Date: Sep 2012
Chapter/Region:
Tri-State
Location: Orange County, NY
Vehicle:2012 WRX stage 2+ DGM (sedan) |
BPV hose fell off...
Just installed my Process West TMIC and a new BPV, then went to take it for a test drive. My car started to idle roughly and give error codes for all 4 cylinders misfiring, so I checked under the hood to see what hoses I forgot to connect. It seems that I accidentally pulled the BPV hose a wee bit too hard when connecting it and I had pulled it out from the other nipple it connects to...
Anyone know where that other connection is supposed to go to?
* Registered users of the site do not see these ads.
|
10-06-2012, 02:39 PM | #2 |
Scooby Specialist
Member#: 327495
Join Date: Jul 2012
Chapter/Region:
Tri-State
Location: Ozone Park, Queens, New York
Vehicle:2012 Impreza WRX 5DR Plasma Blue |
WTF?!
-BUMP- For this guy's sake. |
10-06-2012, 03:42 PM | #3 |
Medium Frank
Moderator Member#: 140114
Join Date: Feb 2007
Chapter/Region:
MAIC
Location: Common Sense, VA
Vehicle:2020 Subaru Outback |
The BPV hose connects to the turbo inlet right before the turbo and again on the BPV obviously.
|
10-06-2012, 04:13 PM | #4 |
Scooby Specialist
Member#: 332887
Join Date: Sep 2012
Chapter/Region:
Tri-State
Location: Orange County, NY
Vehicle:2012 WRX stage 2+ DGM (sedan) |
|
Thread Tools | |
Display Modes | |
|
|