|
|
|
|
Thread Tools | Display Modes |
10-29-2008, 07:14 PM | #1 |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
Speed Sensor, Mystery sensor.
I need a speed sensor for my tranny (6SPEED) AND i also need the sensor that goes on the tail shaft that is white. When pulled i noticed it had a seal around it and it was on the right side ( facing the tail shaft). Should i get these from the dealer or wah?
* Registered users of the site do not see these ads.
|
10-29-2008, 07:37 PM | #2 |
Scooby Newbie
Member#: 189490
Join Date: Sep 2008
Chapter/Region:
MAIC
Location: Baltimore, MD
|
you talking about back-up light switch, or neutral position switch, either way your best bet is to go to the dealer.
|
10-30-2008, 01:16 PM | #3 | |
Former Vendor
Member#: 99694
Join Date: Nov 2005
Chapter/Region:
MAIC
Location: 09 SS GTR
Vehicle:2015 rocketbunny brz red |
Quote:
On the right side, in the tail section, is where the transmission harness enters the transmission to connect to the center differential. The harness clips in, and seals with an o-ring. The tail section of the transmission will need to be removed to replace/reseal the harness. -Dan Andrewtech Automotive |
|
10-30-2008, 03:27 PM | #4 | |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
Quote:
Last edited by smileyou; 10-30-2008 at 03:39 PM. |
|
10-30-2008, 04:07 PM | #5 |
Scooby Newbie
Member#: 189490
Join Date: Sep 2008
Chapter/Region:
MAIC
Location: Baltimore, MD
|
My bad, Dan is right.
Put the tranny vertically, remove the tail and unplug harness from the diff. replace the harness. done deal. This is not that hard, but you need to remove the tail Artie |
10-30-2008, 07:05 PM | #6 |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
When I unplugged the sensor I can see it clipped and I can get it halfway into the hole, is it possible for me to get it unclipped and reclip the new sensor with some tweezers to stabilize the harness and unclip and reclip. And to remove the rear section its only a few bolts, but when I take the tail section off do I have to remove anything or just take the rear tail casing off?? I don't wanna have to remove anything out of the tranny. This would be the first time I opened a tranny . The advice is appreciated.
|
10-31-2008, 06:38 AM | #7 |
Scooby Newbie
Member#: 13680
Join Date: Dec 2001
Location: DCCDPro.com
Vehicle:2002 WRX WRB |
As Dan said, that is not a sensor...it is the electrical connector to your DCCD center diff. The center diff is the cylindrical part that the wires and connector are coming out of in Arty's picture with the finger in it. If you are missing the outer connector and can get another one just use some small medical foreceps or tweezers to hold the inner part while you connect a new one then snap the new one into place to seal the hole.
|
10-31-2008, 08:09 AM | #8 | |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
Quote:
you sir are a shiny golden god. thats the kind of info i was looking for. thank you spiider. im gonna order a dccd from you just for that info lol. |
|
10-31-2008, 04:08 PM | #9 |
Scooby Newbie
Member#: 13680
Join Date: Dec 2001
Location: DCCDPro.com
Vehicle:2002 WRX WRB |
Lol, not a problem. Good luck finding that external connector though, maybe your local dealer can pour over some schematics and dig a part number up for you.
|
10-31-2008, 08:48 PM | #10 |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
its a fiving 80 dollar part....wtf and the speed sensor they lost for my 5speed is 120........WTF. Anyone know if any other sites have cheaper ones.
|
11-01-2008, 12:35 AM | #11 |
Scooby Guru
Member#: 15543
Join Date: Feb 2002
Vehicle:555 Having a Subaru shop means too many cars |
|
11-24-2008, 02:38 PM | #12 |
Scooby Specialist
Member#: 152045
Join Date: Jun 2007
Chapter/Region:
SCIC
Location: Corona/Fontana
Vehicle:2003 PIA wrx wrb..future ppg/fggreen |
bump i changed out the dccd sensor with a hanger and some string. Woot
|
11-24-2008, 05:43 PM | #13 |
Scooby Newbie
Member#: 189490
Join Date: Sep 2008
Chapter/Region:
MAIC
Location: Baltimore, MD
|
LOL good job!
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Disconnected sensor mystery??? | WRX_MAVERICK | Newbies & FAQs | 6 | 05-11-2010 06:25 PM |
Front 02 Sensor,Rear 02 Sensor,MAF Sensor,Blox Shift Knob,SPT Oil Cap, bunch of stuff | TopEndPull | Engine/Power/Exhaust | 11 | 08-14-2009 05:48 PM |
FS (OH): WRX/STi rear o2 sensor, MAF sensor, MAP sensor | coolblue05 | Engine/Power/Exhaust | 14 | 07-07-2009 02:52 PM |
wtb: Tumble Generator Valve (TGV) sensor / Throttle Position Sensor (TPS) Sensor | simprezl25 | Private 'Wanted' Classifieds | 0 | 01-10-2007 04:25 PM |
Mystery sensor under dash? | Geoffman72 | Electrical & Lighting | 5 | 03-29-2004 10:41 PM |